VENLAC HAMMERONTE
Uniform Attractive Hammer Pattern with Full Gloss
Extended Life upto 5-10 Years
Reduces Energy Use
Saves Electricity upto 10-20%
Building Comfort
Reduces Maintenance Expenses
Solar Reflective Paint System

Product Description
The Hammertone Finishes is a one coat spraying finish. When sprayed it gives uniform attractive hammer pattern with full gloss. The Pattern takes care of surface defects and is useful for steel furniture, ovens, motor casing, pump sets etc.

Surface must be clean and sound, free from all dust, oil, grease and other contaminations. Remove all loose material with scrapper or stiff wire brush.

PAINT APPLICATION PROCESS
Sand the surface with emery paper 180 and wipe clean. Apply a first coat of primer depending on the surface of application, choose the appropriate Primer. Allow drying for 6-8 hours. Smoothen the surface by filling dents with thin coats of putty and allow drying for an overnight. Sand the surface with emery paper 180 and wipe clean. Apply another coat of primer and it to dry for 6-8 hrs. Sand the surface with emery paper 320 and wipe clean. Mix VENLAC Synthetic Gloss Enamel with Thinner. Apply 2 coats of this mixture, with a gap of at least 8 hours between coats.

Nature | Liquid |
---|---|
Finish | Uniform Pattern with Full Gloss |
Coverage | 15 - 20 Sq Meters Depending upon Surface & Spraying Conditions |
Drying Time | 10 - 20 Minutes |
Application | By Spray |
Thinning | Not Advisable |
Flash Point | Above 30°C |

PRECAUTIONS
Don’t over thin
Stir well and strain the mixture before use
Avoid the use of Plaster of Paris for dense and cracks
Avoid premature paint failure

Safety Measures
Kindly refer to the MSDS for Venlac Hammertone which gives detailed information on safety measures while handling the paint, which is available on request.
Store the container with the lid tightly closed in an upright position, in a cool, dry place.
Keep out of reach of children and away from eatables.
May be harmful if swallowed. In case of ingestion seek immediate medical attention. In case of skin contact immediately wash skin with soap and plenty of water. Get medical attention if irritation develops or persists.
Wear eye protection during application. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. Do not breathe vapour or spray. It is recommended to wear suitable nose pad during sanding and surface preparation to avoid dust inhalation.
Do not pour leftover paint down the drain or in water courses.
In the event of spills, contain spillage using sand or earth.

